Producing More with Less Tolerance for Error

Upstream operators are being asked to hold or grow production while operating under the tightest emissions and reporting requirements in its history. The old playbook of chasing the production target first, sorting out the environmental file later no longer works. Capital markets won’t fund it, regulators won’t permit it, and buyers won’t reward it. The only path forward is one where production performance and environmental performance are managed by the same data, in the same operating envelope, in real time.

The Pressure on Both Sides is Real

According to the IEA’s most recent decline-rate analysis covering roughly 15,000 fields globally, the average annual post-peak decline rate is now 5.6% for conventional oil and 6.8% for conventional natural gas. Unconventional resources decline far faster, with tight oil and shale gas falling by more than 35% in the first year and another 15% in the second without continued investment. The same analysis found that nearly 90% of annual upstream investment since 2019 has gone toward offsetting production declines, not adding new supply. 

At the same time, demand has not collapsed. Global oil demand is forecast to rise by 2.5 mb/d from 2024 to 2030, reaching roughly 105.5 mb/d, with petrochemicals taking over as the dominant source of growth from 2026 onward. The market still needs the barrels, it just won’t accept them at any environmental cost.

The Old Trade-off is Dead

Operators treated production targets and emissions performance as separate workstreams for decades. Push harder on drawdown, accept higher gas-oil ratios. Defer a workover, accept the rising risk of a casing-vent event. Run the lift system aggressively, accept the higher associated-gas volumes routed to flare.

Those trade-offs are no longer available. Canada’s Enhanced Methane Regulations, finalized in December 2025, are estimated to reduce upstream oil and gas methane by 72% below 2012 levels by 2030, and operators choosing the alternative compliance pathway must demonstrate continuous monitoring outcomes equivalent to or better than the prescriptive rules. Globally, the World Bank’s Zero Routine Flaring by 2030 initiative now has 108 commitments from governments and operators. Whatever pathway an operator selects, the same requirement applies. Prove it with data.

Where the Two Targets Meet at the Wellbore

The good news for operators is that the same downhole measurements protecting production performance also build the compliance record. Here’s three examples:

Drawdown Discipline

Aggressive drawdown on a well with a gas cap or solution-gas drive can pull associated gas faster than infrastructure can capture it, forcing flaring or venting and accelerating reservoir damage at the same time. Real-time bottomhole pressure data lets operators stay below that threshold and protects both the production curve and the emissions ledger.

Wellbore Integrity

A sustained-casing-pressure event detected early through downhole pressure trending allows for a planned, low-emission intervention. The same event missed for six months can require a heavy workover, deferred production, and a measurable spike in lifecycle emissions.

Artificial Lift Optimization

Gas-lift systems running on stale surface estimates frequently overproduce gas relative to liquids, increasing the volume routed to flare and degrading lift efficiency. Real-time bottomhole pressure feedback lets the system operate at the actual inflow performance point by protecting recovery and reducing avoidable emissions in the same loop.

Production Targets Now Include an Emissions Intensity Number

The global market for hydrocarbons is beginning to sort supply by methane intensity. Pembina Institute’s analysis of British Columbia’s experience found that strong methane regulations have driven down emissions even as production grew, and as buyers in Europe, Japan, and South Korea increasingly require verifiable low-methane-intensity supply, that performance is becoming a commercial differentiator. 

This reframes what a production target actually is. A barrel produced with unverified emissions performance is not the same product as a barrel produced with continuous monitoring and a defensible compliance record. By 2030, those two barrels will likely command different prices and access different markets.

The math of upstream production has changed,  and what’s measured at the wellbore now determines what gets sold at the wellhead.GEO PSI builds the downhole pressure and temperature systems that make this possible.

Let’s talk about what your 2030 production and compliance pathway actually requires at the wellbore.

Sources

International Energy Agency, The Implications of Oil and Gas Field Decline Rates, September 2025. https://www.iea.org/reports/the-implications-of-oil-and-gas-field-decline-rates

International Energy Agency, Oil 2025: Analysis and Forecast to 2030, June 2025. https://www.iea.org/reports/oil-2025

Government of Canada / Environment and Climate Change Canada, Reducing Methane Emissions — overview of December 2025 Enhanced Methane Regulations. https://www.canada.ca/en/services/environment/weather/climatechange/climate-plan/reducing-methane-emissions.html

Government of Canada, Canada Gazette, Part II, Volume 159, Number 27 — Regulations Amending the Regulations Respecting Reduction in the Release of Methane and Certain Volatile Organic Compounds (Upstream Oil and Gas Sector), December 31, 2025. https://gazette.gc.ca/rp-pr/p2/2025/2025-12-31/html/sor-dors280-eng.html

World Bank, Zero Routine Flaring by 2030 Initiative. https://www.worldbank.org/en/programs/zero-routine-flaring-by-2030

Pembina Institute, “Canada Must Meet the Moment by Finalizing Methane Regulations,” November 2025. https://www.pembina.org/blog/canada-must-meet-moment-finalizing-methane-regulations

Want to be the first to know? Subscribe to our Newsletter!

Enter your email below and we will send you our latest content directly to your inbox. Be the first to read about topical discussions, and new product releases.

Leave a Reply

More-Articles-Icon-Two-Documents-Blog-News-GEO-PSI
API-Certification-Announcement-GEO-PSI
Top Posts
Jeff Scott

GEO PSI Earns API Spec Q1 Certification

We here at GEO PSI are extremely proud to announce that we are now API Spec Q1 certified! For us here at GEO PSI, our passion is to provide customer satisfaction by manufacturing the most reliable real-time downhole monitoring systems. That’s why everything we do is driven by our motto: Reliability Job 1TM This has

Read More »
Vertical Integration
Novio Kareem

How GEO PSI Mitigates Drift In Downhole Technology

A comprehensive look at drift, its root causes, and how we mitigate drift in our sensors Drift is the gradual change in uncertainty measured by downhole gauges over time. It is measured by the change in sensor output over a long period of time under various pressure and temperature conditions. Exposure to these strenuous environments

Read More »
Landfill-Leachate-Level-&-Distributed-Temperature-Monitoring-GEO-PSI
Downhole Gauges
Jeff Scott

Landfill Leachate Level & Temperature Monitoring

Cost-effective and reliable measurement solutions for even the most unique applications. Landfill Leachate Management Modern landfill management requires strict adhesion to both environmental protection & health and safety legislation. In order to ensure the safety of the site and surrounding environment landfills typically have a protective berm to prevent leachate (contaminated water) from contaminating the

Read More »